TM 5-3895-383-24
Illustration 185
3.
Pump 151 L (40 US gal) of a suitable hydraulic oil into a
208 L (55 US gal) drum.
Illustration 186
(1) 8C-6875 Connector
(2) 8B-5774 Reducer Bushing
(3) 9U-6989 Head
(4) 9U-6983 Filter Element
(5) 6V-3965 Nipple Assembly
(6) 8T-4834 Swivel Orifice Tee
(7) 127-8781 Transfer Cart Group
(8) 2.4 (8 ft) of 25 mm (1 inch) diameter hose.
(9) 3B-6498 Elbow
(10) 3L-7024 Street Elbow
(11) 127-0593 Connector
(12) 3B-7728 Elbow
(13) 3B-7265 Pipe Nipple
(14) 940 mm (37 inch long), 25 mm (1 inch) diameter pipe with
a 45 angle cut at one end.
4.
Use the 127-8781 Transfer Cart Group to flush the oil in
the 208 L (55 US gal) drum. Filter the oil for 30 minutes.
The particle count of the clean oil must be a maximum
of ISO 18/13.
Illustration 187
5.
Raise the machine. The drum and tires must not be in
contact with the ground or the floor. Support the
machine on stands.
Illustration 188
6.
Start the engine. Release the parking brake and rotate
the drum until the fill/drain plug is at the top of the
housing. Remove the plug. Install the valve and fitting
assembly that is appropriate for your machine.
Illustration 189
Maintenance Section
Eccentric Weight Housing Oil - Change
1-86
