TM 5-3895-383-24
Magnetic Pickup
Typical Illustration
(1) Clearance between magnetic pickup and flywheel
ring gear ............................ 0.55 to 0.83 mm (.022 to .033 in)
NOTE:
With the engine stopped, turn the pickup in until it
comes in contact with the teeth on the flywheel
ring gear. Turn the pickup out 1/2 turn. This will
give 0.55 to 0.83 mm (.022 to .033 in) clearance.
(2) Tighten the locknut to a torque of .......................45 7 Nm
(33 ± 5 lb-ft)
Oil Pressure Switch
Oil Pressure Switch
Tools Needed
Source of Hydraulic pressure.
1
6V7835
Transmission Hydraulic Test Group.
1
8T0500
Circuit Tester.
1
NOTE:
For the pressure at which each circuit will be
switched find the switch in specifications section
of this manual.
1.
Connect the oil pressure switch to a pressure source
that can be measured with accuracy.
2.
Connect a circuit tester between terminal (2) and
terminal (1).
3.
With pressure increase, the circuit light will light.
4.
With pressure decrease, the circuit light will go out.
5.
If the switch fails to operate at the correct pressures,
replace the switch.
7-27
