TM 5-3895-383-24
NOTE
· Shims are required if gap between plates and yoke is greater than 2mm.
· Blade arms should be centered on yoke.
(9)
Determine amount of shims required to center blade assembly (5) on yoke (12).
(10)
Loosen eight nuts (7) only enough to allow shims (10) to be added.
(11)
Install shims (10) between plates (11) and yoke (12).
(12)
Install two washers (8), bolts (9), washers (8) and nuts (7) in plates ( 11), and yoke (12).
(13)
Tighten ten nuts (7) to 340 lb-ft (460 Nm).
(14)
Remove lifting devices.
NOTE
Follow-on Maintenance: Remove chocks.
END OF TASK
2-24