TM 5-3895-383-24
2-2. COLD STARTING AID REPLACEMENT
This Task Covers
a. Removal
b. Installation
INITIAL SETUP
Tools and Special Tools
Materials/Parts
Tool Kit, General Mechanic's: Automotive
Lockwasher
(SC 5180-90-N26), Tool Number W33004,
Cable Ties, MILS-29190, NSN 5975-00-984-6582
NSN 5180-00-177-7033
Equipment Condition
Engine OFF (TM 5-3895-383-10)
Drum and wheels chocked
Hood Opened (TM 5-3895-383-10)
a.
Removal
NOTE
Steps (1) through (3) apply only when
ether canister is installed. If Roller's
mission has not required installation of
ether canister, begin with Step (4).
(1)
Loosen wing nut (1) and remove ether canister
(2) from clamp (3) and valve (4).
(2)
Remove cap (S) from cap holder (6).
(3)
Install cap (5) on valve (4).
(4)
Cut and remove cable tie (7) from connector
(8).
(5)
Disconnect connector (8) from wiring harness
(9).
(6)
Loosen connector (10) and remove tube (11)
from valve (4).
(7)
Remove two nuts (12), washers (13), clamps
(14), washers (13), bolts (15), and brackets
(16) from hydraulic oil tank (17).
(8)
Remove two clamps (13) from tube (11).
(9)
Remove tube (11) from apron (18).
2-3
