TM 5-3895-383-24
2-1. BACK-UP ALARM OVERRIDE SWITCH
This Task Covers:
a. Removal
b. Installation
INITIAL SETUP
Tools and Special Tools
Materials/Parts
Tool Kit, General Mechanic's: Automotive
Lockwasher
(SC 5180-90-N26), Tool Number W33004,
Cable Ties, MIL-S-29190, NSN 5975-00-984-6582
NSN 5180-00-177-7033
Wrench, Torque (0-175 lb-ft),
Equipment Condition
NSN 5120-00-640-6364
Engine OFF (TM 5-3895-383-10)
Battery disconnect switch turned OFF
(TM 5-3895-383-10)
Drum and wheels chocked
a.
Removal
(1)
Open hood (1)(TM 5-38895-383-10).
(2)
Cut and remove cable ties (2) from wiring
harness (3) and bracket (4). Discard cable
ties.
(3)
Remove nut (5), lockwasher (6), and switch (7)
from bracket (8). Discard lockwasher.
(4)
Tag, mark, and disconnect two wires (9 and
10) from switch (7).
(5)
If damaged, removed two nuts (11), washers
(12), bracket (4), two bolts (13), and bracket (8)
from backup alarm (14) and hood (1).
b.
Installation.
(1)
If removed, install bracket (8) to backup alarm
(14) and hood (1) with two bolts (13), bracket
(4) two washers (12), and nuts (11). Tighten
nuts to 40 lb-ft (55 Nm).
(2)
Install two wires (9 and 10) on switch (7).
(3)
Install switch (7) in bracket (8) with lockwasher
(6) and nut (5).
(4)
Attach wiring harness (3) to bracket (4) with
cable ties (2).
(5)
Close hood (1) (TM 5-38895-383-10).
NOTE
Follow-on Maintenance: Remove chocks.
END OF TASK
2-2
