TM 5-3895-383-24
Inspect the cooling system for leaks, damaged hoses, or trash.
Repair any leaks. Remove any trash from the radiator.
Inspect the engine attachments for wear or damage.
Replace any components that are worn or damaged.
Inspect the hydraulic system for leaks. Inspect the following
components: the hydraulic tank the cylinder rod seals the
hoses the lines the fittings. Repair any leaks. Repair any
damaged components or worn components.
Inspect the rear axle for any leaks.
Inspect the tires for damage. Check the tires for proper
inflation. Replace missing valve caps.
Make sure that all covers and guards are firmly in place.
Check the guards and covers for damage.
Inspect the steps, walkways, and handholds for damage or
wear. Check the steps, walkways and handholds for
cleanliness. Inspect the Rollover Protective Structure (ROPS)
for damage. If repair is necessary, consult your Caterpillar
dealer. Tighten any loose bolts.
Inspect the operator compartment for cleanliness. Keep the
operator compartment clean.
If equipped, adjust the rear view mirrors for the best vision.
Illustration 311
Inspect the rubber isolation blocks for damage, cracking, or
splitting.
Window Cleaning
Use a commercially available cleaning solution in order to
clean the windows. Unless handholds are available, clean the
outside windows from the ground.
Wheel Drive Gearbox Oil - Change
SMCS Code: 4050-044-OC
Illustration 312
1.
Remove the drain plug (2).
2.
Drain the oil into a suitable container.
3.
Clean the drain plug, and install the drain plug.
4.
Remove the level check/fill plug (1).
5.
Add oil to the gearbox. Fill the gearbox to the bottom of
the level check/fill plug opening.
6.
Refer to page 1-10.
7.
Clean the level check/fill plug and install the level
check/fill plug.
Maintenance Section
Wheel Drive Gearbox Oil - Change
1-127
