TM 5-3895-383-10
Operation Section
4-30
Machine Controls
Steering Frame Lock
SMCS Code: 7506
No clearance for person in this area when machine
turns. Severe injury or death from crushing could
occur.
Install the steering frame lock pin between the front
frame and the rear frame before you lift the machine
and before you transport the machine on another
vehicle. Also install the steering frame lock pin before
you perform maintenance near the center of the
machine.
In order to install the steering frame lock pin, the
machine must be in the straight ahead position.
1. Apply the parking brake.
2. Turn the engine start switch to the OFF position.
Illustration 40
3. After the machine has been moved into position,
install the steering frame lock pin. The pin will hold
the front frame and the rear frame rigid. Remove
the pin (2). Lower the steering frame lock pin (1).
Reinstall the pin (2).
Illustration 41
4. In order to unlock the steering frame, reverse the
steps that are used to lock the steering frame.
Tilt Hood
SMCS Code: 1427; 7251-T2; 7251
Illustration 42
The hood must be raised in order to access the engine
compartment. The switch that controls the hood is
located on the right rear of the machine.
