TM 5-3895-383-10
3-22
3-10. SLAVE START ROLLER (CONT)
(4) Remove caps (1) from NATO receptacles (2)
on other vehicle and Roller.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits a direct short may
result. Damage to equipment, injury or death
to personnel may occur.
Ensure connectors and receptacles are
free of dirt, sand, and debris.
(5) If equipped, remove caps (3) from NATO slave cable
connector (4).
(6) Plug NATO slave cable connector (4) into NATO
receptacle on other vehicle and Roller.
(7) Start other vehicle (refer to other vehicle’s Operator’s
Manual).
(8) Operate other vehicle at high idle (refer to other vehicle’s Operator’s Manual) while attempting to
start Roller engine. Ensure battery disconnect switch is turned on (page 3-5).
(9) When Roller engine is running smoothly, remove NATO slave cable connectors (4) from NATO
receptacles (2) of other vehicle and Roller.
(10) If equipped, install caps (3) on NATO slave cable connectors (4).
(11) Install caps (1) on NATO receptacles (2) of other vehicle and Roller.
(12) Move and park other vehicle (refer to other vehicle’s Operator’s Manual).
(13) Shut off other vehicle (refer to other vehicle’s Operator’s Manual).
3-11. NUCLEAR, BIOLOGICAL, AND CHEMICAL (NBC) DECONTAMINATION
PROCEDURES
The Decontamination Kit bracket is mounted on the rear of the Roller. Refer to TM 3-4230-214-12&P for
operation of Decontamination Kit.
