TM 5-3895-382-10
2-23
Table 2-1. Operator Preventive Maintenance Checks and Services – CONT.
Item
No.
Interval
Man-
hour
Item to be
Checked or
Serviced
Procedure
Equipment Not
Ready/Available if:
33 During
0.1
Hydraulic Oil
Level (Warm
Oil Check)
Do not overfill hydraulic oil tank.
Damage to hydraulic system
components may occur.
NOTE
The Roller must be parked on a
level surface when checking the
hydraulic oil level.
Hydraulic oil shall be checked
warm and cold. Engine shall be
run at least five minutes before
performing warm oil check.
Disregard markings on sight
gauge. Maintain hydraulic oil level
according to label markings.
a. Open left side door assembly.
b. Check that hydraulic oil level is
between the high and low marks on
the label beside the hydraulic oil tank
sight gauge. If level is below “LOW”
level mark, fill hydraulic tank with
hydraulic oil (page 2-5).
c. Close left side door assembly.
Hydraulic oil level is
below “LOW” level
mark, or above
“HIGH” level mark on
label.
34 After
0.1
Fuel Level
Check fuel level gauge. Fill fuel tank, if
level is low.
Fuel level is very low
or empty.
