TM 5-3895-379-23
YOKE REPLACEMENT - CONTINUED
0198 00
REMOVAL - CONTINUED
2.
Position wooden blocks under roller as shown.
401-882
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
3.
Attach lifting straps and a lifting device to position yoke (4) as shown.
4.
Install guide bolts (10).
NOTE
Use marks on shims to note location for installation purposes.
Shims are located between plate and pivot housing.
5.
With assistance, position bottom plate (8) on yoke (4).
6.
Remove four bolts (5), washers (6) and shims (7) from bottom plate (8). Inspect shims for damage or worn condition,
replace as necessary.
NOTE
Use marks on shims to note location for installation purposes.
7.
Remove two outside top bolts (9) and install two M24 x 3.0 guide bolts (10). Remove remaining two bolts (9) and shims
(7).
NOTE
Weight of plate is 85 lb (39 kg).
8.
With assistance, remove plate (6) from yoke (4) and guide bolts (10).
NOTE
Weight of yoke is 2300 lb (1044 kg).
9.
With assistance, use lifting device to remove yoke (4) from roller.
0198 00-2