TM 5-3895-379-23
SIDE DRAIN COCK AND VALVE REPLACEMENT - CONTINUED
0158 00
REMOVAL - CONTINUED
5.
Remove two adapters (4) and tee (8) from valve (10).
6.
Remove drain cock (11) from tee (8).
NOTE
Note position of valve and tee prior to removal.
7.
Remove valve (10) from tee (8) (CB534B Roller).
10
8
4
4
11
401-784
CLEANING AND INSPECTION
1.
Clean tee, fittings and drain cock with detergent and water. Remove difficult deposits with a cleaning brush.
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (20 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Failure to follow this warning may cause injury or death. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user must wear
protective goggles or face shield.
2.
Use a cleaning cloth or compressed air to dry metal parts.
3.
Check tee for clogging, corrosion or excessive wear.
4.
Check drain cock and valve for clogging, corrosion, excessive wear and obvious signs of damage.
5.
Check all parts for stripped or damaged threads.
6.
Replace all damaged parts.
INSTALLATION
1.
Apply sealing compound to threads and install valve (10) and drain cock (11) in tee (8).
2.
Install two adapters (4) and tee (8) on valve (10) (CB534B Roller).
0158 00-2
