TM 5-3895-379-23
RADIATOR ASSEMBLY REPLACEMENT - CONTINUED
0050 00
REMOVAL - CONTINUED
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning could cause injury or death.
NOTE
Weight of radiator is 90 lb (41 kg).
5.
Attach lifting device to radiator (3).
6.
With assistance, remove eight bolts (8), washers (9), two clips (7), overflow hose (6) and radiator (3) from oil cooler
(10). Remove lifting device.
7.
Remove drain cock (11) from radiator (3).
8.
Loosen clamp (12) and remove cap (13) from radiator (3).
INSTALLATION
1.
Install cap (13) and clamp (12) on radiator (3). Tighten clamp until secure.
2.
Install drain cock (11) on radiator (3).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning could cause injury or death.
NOTE
Weight of radiator is 90 lb (41 kg).
3.
Attach lifting device to radiator (3).
4.
With assistance, install radiator (3) on oil cooler (10) with six washers (9) and bolts (8) leaving two holes open for clips
(7). Remove lifting device.
5.
Position two clips (7) on overflow hose (6).
6.
Install two clips (7) and overflow hose (6) on oil cooler (10) with two washers (9) and bolts (8).
7.
Install overflow hose (6) on radiator (3).
NOTE
Bottom four bolts on backside cannot be measurably tightened due to location. Torque wrench will not fit
between oil cooler and frame.
8.
Tighten eight bolts (8) to 33-47 lb-ft (45-64 Nm). Ensure two clips (7) do not turn and restrict overflow hose (10).
0050 00-3