TM 5-3895-379-23
OIL PAN REPLACEMENT - CONTINUED
0020 00
REMOVAL - CONTINUED
4.
Remove plug (8) and O-ring (9) from oil pan (2). Dis-
10
8
9
card O-ring.
(HIDDEN)
14
11
5.
Remove insert (10) and plug (11) from oil pan (2).
6.
Remove drain valve (12) and O-ring (13) from oil pan
(2). Discard O-ring.
89
7.
Remove felt dust seal (14) from oil pan (2). Discard
seal.
13
12
2
401-262
INSTALLATION
WARNING
Adhesive causes immediate bonding on contact with eyes, skin or clothing and also gives off harmful
vapors. Wear protective goggles and use in well-ventilated area. If adhesive gets in eyes, try to keep
eyes open; flush eyes with water for 15 minutes and get immediate medical attention.
Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and are harm-
ful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated
area. If adhesive, solvent or sealing compound gets on skin or clothing, wash immediately with soap
and water.
NOTE
Ensure mating surfaces are clean.
1.
Install new felt dust seal (14) on oil pan (2) using gasket cement.
CAUTION
Ensure drain valve is in the closed (full right) position after installation. Failure to follow this caution may
cause damage to equipment.
2.
Install new O-ring (13) and drain valve (12) on oil pan (2). Place drain valve in closed position.
3.
Install plug (11) and insert (10) on oil pan (2).
4.
Install new O-ring (9) and plug (8) on oil pan (2).
0020 00-3
