TM 5-3895-379-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 6. Vibratory System Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Check power to vibratory control. 1. If 24 to 28 Vdc are not measured
11. Vibration Occurs In Only One
Drum.
Open left-side door assembly
at terminal 1 (wire C923-BU for
(TM 5-3895-379-10). If rear
rear drum or C927-PU for front
drum does not vibrate, disconnect
drum), turn engine start switch and
harness connector from rear drum
battery disconnect switch to OFF
position (TM 5-3895-379-10).
does not vibrate, disconnect
Connect harness connector to
harness connector from front
solenoid connector.
battery disconnect switch and 2. If 24 to 28 Vdc are not measured
at terminal 1 (wire C923-BU for
engine start switch to ON position
rear drum or C927-PU for front
(TM
5-3895-379-10).
Set
drum), press vibration on/off
Touch positive (+) probe of
switch once and try again. If 24 to
28 Vdc are still not measured at
C923-BU for rear drum or C927-
terminal 1 (wire C923-BU for rear
PU for front drum) and negative
drum or C927-PU for front drum)
(-) probe of multimeter to good
and VIBE fuse is good, turn engine
ground.
start switch to off position (TM 5-
3895-379-10). Connect harness
connector to solenoid connector.
Go to Step 2.
WIRE C923-BU
WIRE C927-PU
HARNESS CONNECTORS
FRONT DRUM SOLENOID
REAR DRUM SOLENOID
401-2109