TM 5-3895-379-23-2
0273
WATER LINES REPLACEMENT
NOTE
Use table below and Figure 4 to locate ends of all water lines on roller.
Tag and mark each end of water line before removal.
Cut electrical tiedown straps as necessary to remove water lines.
When replacing water lines, remove tubing from roller, remove fittings, cut new tubing 1/4-1/2
in. (6-13 mm) longer than tubing being replaced, then install fittings.
Table 1. Water Lines.
From
To
Water Line
Figure 4, Item 1
Rear Tee (Figure 4, Item 4)
Rear Water Spray Pipe
(Figure 4, Item 10)
Figure 4, Item 5
Rear Water Spray Pump
Rear Tee (Figure 4, Item 4)
(Figure 4, Item 6)
Figure 4, Item 7
Rear Water Spray Filter
Rear Water Spray Pump
(Figure 4, Item 3)
(Figure 4, Item 6)
Figure 4, Item 2
Rear Water Spray Tank
Rear Water Spray Filter
(Figure 4, Item 26)
(Figure 4, Item 3)
Figure 4, Item 11
Rear Check Valve
Rear Water Spray Pipe
(Figure 4, Item 9)
(Figure 4, Item 10)
Figure 4, Item 12
Front Tee (Figure 4, Item 17)
Side Tee and Drain Cock
(Figure 4, Item 24)
Figure 4, Item 13
Front Tee (Figure 4, Item 17)
Front Water Spray Pipe
(Figure 4, Item 22)
Figure 4, Item 15
Front Water Spray Tank
Front Water Spray Filter
(Figure 4, Item 14)
(Figure 4, Item 16)
Figure 4, Item 18
Front Water Spray Pump
Front Tee (Figure 4, Item 17)
(Figure 4, Item 19)
Figure 4, Item 20
Front Water Spray Filter
Front Water Spray Pump
(Figure 4, Item 16)
(Figure 4, Item 19)
Figure 4, Item 23
Front Check Valve
Front Water Spray Pipe
(Figure 4, Item 21)
(Figure 4, Item 22)
Figure 4, Item 8
Rear Tee (Figure 4, Item 4)
Side Water Spray Valve
(Figure 4, Item 25)
03/15/2011Rel(1.8)root(maintwp)wpno(M00211)
