TM 5-3895-379-23-2
0265
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
Weight of drum assembly is 4,750 lb (2,155 kg).
1.
Remove chocks (TM 5-3895-379-10). Place drum assembly (Figure 9, Item 4) into lifting device.
2.
Raise drum assembly (Figure 9, Item 4) until it is just off floor. Move drum assembly into roller yoke or frame.
NOTE
The CB534B Roller model has shims between drum support (Figure 10, Item 1) and yoke
(Figure 10, Item 3) on vibratory side of drum assembly. Note the number of shims when
replacing six bolts.
3.
On vibratory side of drum assembly (Figure 9, Item 4), install six bolts (Figure 10, Item 5) and washers
(Figure 10, Item 4) that fasten drum support (Figure 10, Item 1) to yoke (Figure 10, Item 3). For the CB534B
Roller, install shims (Figure 10, Item 2).
4.
On propel side of drum assembly (Figure 9, Item 4), install eight bolts (Figure 10, Item 7) and washers
(Figure 10, Item 8) that fasten drum support (Figure 10, Item 1) to yoke (Figure 10, Item 3).
5.
Remove the lifting device from drum assembly (Figure 9, Item 4). Remove jackstands from both sides of yoke
(Figure 10, Item 3).
6.
For the rear drum assembly (Figure 9, Item 4), connect six hose assemblies (Figure 9, Item 1) to propel motor
(Figure 9, Item 2).
0265-10
03/15/2011Rel(1.8)root(maintwp)wpno(M00203)
