TM 5-3895-379-23-2
0264
ECCENTRIC DISASSEMBLY - Continued
NOTE
Place alignment marks on weight assembly components for assembly.
13.
Remove lifting brackets from weight assembly (Figure 6, Item 1) and remove four bolts (Figure 6, Item 2), eight
nuts (Figure 6, Item 18), four tabs (Figure 6, Item 19), and shaft (Figure 6, Item 3) from counter weight
(Figure 6, Item 4).
14.
Remove weight (Figure 6, Item 5) from counter weight (Figure 6, Item 4).
15.
Remove counter weight (Figure 6, Item 4) from shaft (Figure 6, Item 11). Remove six bolts (Figure 6, Item 6)
and washers (Figure 6, Item 7) that fasten thrust block (Figure 6, Item 8) to shaft (Figure 6, Item 11).
16.
Use three forcing screws to remove thrust block (Figure 6, Item 8) from shaft (Figure 6, Item 11).
17.
Remove, as a unit, spur (Figure 6, Item 9), spring (Figure 6, Item 10), shaft (Figure 6, Item 13), drive key
(Figure 6, Item 16), and pin (Figure 6, Item 17) from shaft (Figure 6, Item 11).
18.
Remove spring (Figure 6, Item 10) from shaft (Figure 6, Item 13).
19.
Remove oil ring (Figure 6, Item 14), ring (Figure 6, Item 15), and sleeve (Figure 6, Item 12) from shaft
(Figure 6, Item 11).
20.
Remove pin (Figure 6, Item 17) and drive key (Figure 6, Item 16) from shaft (Figure 6, Item 11).
0264-10
03/15/2011Rel(1.8)root(maintwp)wpno(M00202)