TM 5-3895-379-23-2
0231
INSTALLATION
NOTE
Step (1) applies to right-side door assembly only.
1.
If removed, install four air seals (Figure 9, Item 7) and plates (Figure 9, Item 5) on door assembly
(Figure 9, Item 6) with 12 bolts (Figure 9, Item 4), washers (Figure 9, Item 3), and nuts (Figure 9, Item 2).
Tighten nuts to 84-132 lb-in. (9-15 Nm).
2.
If removed, install two supports (Figure 9, Item 10) on yoke assembly (Figure 9, Item 5) with four washers
(Figure 9, Item 14) and screws (Figure 9, Item 13). Tighten screws to 33-47 lb-ft (45-64 Nm).
3.
If removed, install two catches (Figure 9, Item 9) on support (Figure 9, Item 10) with four bolts
(Figure 9, Item 8), washers (Figure 9, Item 11), and nuts (Figure 9, Item 12). Tighten nuts to 33-47 lb-ft
(45-64 Nm).
1
2
3
4
13
14
12
11
7
10
9
6
8
5
M1176SWR
Figure 9. Door Assembly Installation.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
Door assemblies weigh 100 lb (45 kg) each.
4.
Attach lifting device to door assembly (Figure 10, Item 4).
5.
Install door assembly (Figure 10, Item 4) on frame assembly (Figure 10, Item 1) with five washers
(Figure 10, Item 2) and bolts (Figure 10, Item 3). Turn bolts until snug, but do not tighten bolts.
03/15/2011Rel(1.8)root(maintwp)wpno(M00169)