TM 5-3895-379-23-2
0228
REMOVAL - Continued
2.
Position wooden blocks (Figure 2, Item 1) under roller as shown.
1
M0708SWR
Figure 2. Yoke Removal.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
3.
Attach lifting straps and a lifting device to position yoke (Figure 3, Item 7) as shown.
4.
Install guide bolts (Figure 3, Item 1).
NOTE
Use marks on shims to note location for installation purposes.
Shims are located between plate and pivot housing.
5.
With assistance, position bottom plate (Figure 3, Item 3) on yoke (Figure 3, Item 7).
6.
Remove four bolts (Figure 3, Item 5), washers (Figure 3, Item 6), and shims (Figure 3, Item 4) from bottom
plate (Figure 3, Item 3). Inspect shims for damage or worn condition, replace as necessary.
NOTE
Use marks on shims to note location for installation purposes.
7.
Remove two outside top bolts (Figure 3, Item 2) and install two M24 x 3.0 guide bolts (Figure 3, Item 1). Remove
remaining two bolts (Figure 3, Item 2) and shims (Figure 3, Item 4).
03/15/2011Rel(1.8)root(maintwp)wpno(M00166)
