TM 5-3895-379-23-2
0222
ASSEMBLY - Continued
1
2
3
4
5, 6
7
5, 6
9
8
M0681SWR
Figure 14. Steering Control Unit (SCU) Assembly.
NOTE
The steering control unit (SCU) must be timed, this required the correct relationship
between pin, gerotor and housing. One end of pin will point to the largest clearance
between the gerotor and gerotor housing. The other end of the pin points to the least
clearance.
Pin cannot be seen after drive is installed, so it will be necessary to make a mark on the
gear end of the drive for proper alignment.
Be sure the bolt holes in the spacer plate align with the tapped holes in the center housing.
14.
Install spacer plate (Figure 15, Item 3).
NOTE
Be sure the slot in drive (Figure 15, Item 6) engages with pin (Figure 15, Item 3).
15.
Install drive (Figure 15, Item 6) and spacer (Figure 15, Item 2) in gerotor (Figure 15, Item 1).
16.
Install new seal (Figure 15, Item 5) in gerotor housing (Figure 15, Item 4).
17.
Position gerotor housing (Figure 15, Item 4) on steering control unit.
2
1
4
5
3
6
4
M0684SWR
Figure 15. Steering Control Unit (SCU) Assembly.
03/15/2011Rel(1.8)root(maintwp)wpno(M00160)
