TM 5-3895-379-23-1
0136
INSTALLATION
1.
Install cap and clamp on radiator (Figure 3, Item 6). Tighten clamp until secure.
2.
Install drain cock on radiator (Figure 3, Item 6).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
Weight of radiator is 90 lb (41 kg).
3.
Attach lifting device to radiator (Figure 3, Item 6).
4.
With assistance, install radiator (Figure 3, Item 6) on oil cooler (Figure 3, Item 2) with six washers
(Figure 3, Item 4) and bolts (Figure 3, Item 3) leaving two holes open for clips (Figure 3, Item 5). Remove
lifting device.
5.
Position two clips (Figure 3, Item 5) on overflow hose (Figure 3, Item 1).
6.
Install two clips (Figure 3, Item 5) and overflow hose (Figure 3, Item 1) on oil cooler (Figure 3, Item 2) with two
washers (Figure 3, Item 4) and bolts (Figure 3, Item 3).
7.
Install overflow hose (Figure 3, Item 1) on radiator (Figure 3, Item 6).
NOTE
Bottom four bolts on backside cannot be measurably tightened due to location. Torque
wrench will not fit between oil cooler and frame.
8.
Tighten eight bolts (Figure 3, Item 3) to 33-47 lb-ft (45-64 Nm). Ensure two clips (Figure 3, Item 5) do not turn
and restrict overflow hose (Figure 3, Item 1).
0136-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00074)