TM 5-3895-379-23-1
0125
TANK REMOVAL - Continued
28.
Remove two locknuts (Figure 16, Item 4), washers (Figure 16, Item 3), and strap assemblies
(Figure 16, Item 1) from frame assembly (Figure 16, Item 2). Discard locknuts.
1
2
3
4
M0527SWR
Figure 16. Fuel/Hydraulic Oil Tank Removal.
29.
Remove two nuts (Figure 17, Item 4), washers (Figure 17, Item 7), screws (Figure 17, Item 6), and strap
assemblies (Figure 17, Item 5) from frame assembly (Figure 17, Item 3).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
CAUTION
Place fuel/hydraulic oil tank on blocks and position tank so that connectors and hoses can
be removed and installed. Do not allow weight of tank to rest on connectors. Failure to follow
this caution may cause damage to tank and connectors.
NOTE
Fuel/hydraulic oil tank weighs 360 lb (163 kg).
Fuel/hydraulic oil tank must be pushed or pried toward rear of roller to allow fuel/hydraulic
oil tank bosses to clear cut-outs in frame assembly during removal.
30.
Attach a lifting device to lift points of fuel/hydraulic oil tank (Figure 17, Item 2). Remove tank from frame
assembly (Figure 17, Item 3) with lifting device while assistants pry tank free from frame assembly
(Figure 17, Item 3) and guide tank through ROPS (Figure 17, Item 1).
03/15/2011Rel(1.8)root(maintwp)wpno(M00063)
