TM 5-3895-379-10
HYDRAULIC OIL LEVEL CHECK AND SERVICE - CONTINUED
0018 00
FILL HYDRAULIC OIL TANK
WARNING
DO NOT remove hydraulic oil cap assembly when hydraulic system is hot. Allow hydraulic oil to cool.
Loosen slowly and let any pressure out of hydraulic system, then remove cap. Failure to follow this
warning may cause burns.
Oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause injury.
1.
Remove padlock (2) from hydraulic oil cap assembly (3).
2.
Lift lever and remove hydraulic oil cap assembly (3) from hydraulic oil tank (4) by turning cap counterclockwise.
3.
Remove strainer (5) from hydraulic oil tank (4) and
LEVER
inspect for debris. Remove debris as necessary.
4.
Clean and install strainer (5) in hydraulic oil tank (4).
2
6
NOTE
4
1
Refer to KEY in WP 0011 00 for quantity
and type of oil.
3
5.
Add oil through strainer (5) and fill tube (6) until oil
5
level indicator (1) is between FULL and ADD marks
on decal located beside hydraulic oil level indicator.
6.
Lift lever and install hydraulic oil cap assembly (3) on
hydraulic oil tank (4) by turning cap clockwise.
7.
Install padlock (2) on hydraulic oil cap assembly (3)
DECAL
while lever is fully down.
401-101
END OF WORK PACKAGE
0018 00-2
