TM 5-3895-346-14
HYDROSTATIC SYSTEM
PUMP REPAIR
Figure 64.
Figure 65.
The end cap will align with the housing mounting holes in one position only (refer to Fig. 65).
Install two screws and tighten alternately until the internal spring has compressed far enough for the end cap to
rest on the housing. Install the remaining capscrews (refer to Fig. 66).
Figure 66.
Figure 67.
Install the shaft seal as the last step in reassembly of the basic pump (refer to Fig. 67 and 68).
Figure 68.
Install the remaining major assemblies (control valve, check valves and charge pump) as outlined in Minor
Repair Procedures.
CAUTION
Fill the pump housing with clean hydraulic oil.
551
