TM 5-3895-346-14
HYDROSTATIC SYSTEM
MOTOR REPAIR
Figure 9.
Figure 11.
The tapered bearing must now be removed from the shaft. A bearing puller should be used that will pull
against the inner race of the bearing. Protect the cylinder block face during this operation (refer to Fig. 10).
After removal of the bearing, slip the spacer out of the bore in the cylinder block (refer to Fig. 11).
Place the motor in a horizontal position. Slide the cylinder block assembly off the shaft while holding the
external end of the shaft (refer to Fig. 12).
Figure 10.
Figure 12.
521
