TM 5-3895-346-14
CAMSHAFT AND BEARINGS
ENGINE OVERHAUL
Figure 10. Camshaft and Balance Shaft Details and Relative Location of Parts
Figure 11. Camshaft Plug Iristallation
8. Attach the gear nut retainer plates (if used) to the gears with bolts and lockwashers, and tighten the
bolts to 35-39 lb ft (47-53 Nm) torque.
9. Check the clearance between the thrust washer and the gear on both shafts. The clearance should be
0.005 to 0.015 inch, or a maximum of 0.019 inch with used parts.
10. Check the backlash between the mating gears. The backlash should be 0. 003 to 0.005 inch and
should not exceed 0.007 inch between used gears.
11. Install the flywheel housing and other parts or assemblies that were removed from the engine as
outlined in their respective sections of this manual.
180
