(2) Press the cluster gage (14) against the instrument panel bracket (13) and install the mounting clamps (5) on
the cluster gage studs.
(3) Install and tighten the cluster gage clamp nuts (6).
(4) Connect the starter button lead (2) and the oil gage lead (3) with the oil gage terminals. Tighten the terminal
nuts (4).
(5) Connect the fuel gage lead (7) with the fuel gage terminal. Tighten the terminal nut (8).
(6) Connect the temperature gage lead (16) with the temperature gage terminal. Tighten the terminal nut (15).
(7) Connect the ammeter leads with the arnmeter terminals. Tighten the terminal nuts (21).
(8) Connect the battery ground cable with the battery terminal. Refer to paragraph 111h.
e. Instrument Panel Removal.
(1) Remove the cluster gage (b above).
(2) Remove the starter button terminal nuts (1) and disconnect the leads from the terminals. Tag the leads to
facilitate installation.
(3) Remove the starter button flange nut in the front of the instrument panel. Remove the starter button.
(4) Disconnect the leads from the ignition switch (20). Tag the leads.
(5) Unscrew the ignition switch mounting nut and remove the ignition switch (20) from the instrument panel.
(6) Remove the capacitor mounting nut (18) and remove the capacitor (19).
(7) Disconnect the choke cable (9) from the carburetor.
(8) Unscrew the choke cable mounting nut (10) and pull the choke cable (9) from the instrument panel.
(9) Disconnect the throttle cable (11) from the carburetor.
(10) Unscrew the throttle cable mounting nut (12) and pull the throttle cable from the instrument panel.
(11) Use a cutting torch to remove the instrument panel bracket (13) from the compression roll housing. Do not
use too much heat as it may cause the bracket or roll housing to warp. Place an asbestos sheet under the
instrument panel and watch the molten metal drippings. Be careful not to damage or burn electrical leads or
adjacent parts.
f. Instrument Panel Installation.
(1) Weld the instrument panel bracket (13) to the compression roll housing. Clean and paint the weld.
(2) Insert the throttle cable (11) in its mounting hole on the instrument panel and tighten the mounting nut (12).
Connect the throttle cable with the carburetor.
(3) Insert the choke cable (9) in its mounting hole on the instrument panel and tighten the mounting nut (10).
Connect the choke cable to the carburetor.
109
