TM 5-3895-383-24
Vibratory Motor
(CS-563D & CP563D)
Remove & Install Vibratory Motor
(CS-563D & CP563D) 5058-010
At operating temperature, the hydraulic oil tank is hot and
under pressure. Hot oil can cause burns. Remove the fill
plug only when the engine is stopped and when the fill
plug is cool enough to touch with your bare hands.
1.
Release the pressure in the hydraulic system (page 14-7).
2.
Drain the hydraulic oil from the hydraulic oil tank. The
capacity of the hydraulic oil tank is 80 liters (21.1 U.S.
gal).
3.
Disconnect three hose assemblies (3) from vibratory
motor (1). Cap and plug immediately.
4.
Remove two bolts (2), and remove vibratory motor (1)
and the O-ring seal from the drum support housing.
Check the O-ring for wear or damage and replace if
necessary. The weight of the vibratory motor is 17 kg
(37.4 lb). When installing, apply 6V-4876 Molykote
Paste Lubricant to the splines of the motor and use
9S-3263 Thread Lock on the two bolts.
NOTE:
For installation of the vibratory motor, reverse the
removal steps.
NOTE:
After the vibratory motor has been installed, fill
the drum support housing and hydraulic oil tank
with oil to the correct level. See the Operation &
Maintenance Manual for the correct procedure.
14-117
