TM 5-3895-383-24
2.
Put rubber toric ring (2) on seal ring (1). Make sure that
the toric ring is at the bottom of seal ring ramp (7) and
against seal ring retaining lip (8).
NOTE:
Make sure that rubber toric ring (2) is straight on
seal ring (1). There must not be a twist in the toric
ring. Be careful when you are working on the
rubber toric ring. Nicks, cut and scratches can
cause leaks.
3.
Put installation tool (9) on seal ring (1) with rubber toric
ring (2). Lower the rings into a container of isopropyl
alcohol until all surfaces of rubber toric ring (2) are wet.
NOTE:
Do not use Stanisol or any other liquid that may
leave an oily film.
4.
While all surfaces of rubber toric ring (2) are still wet,
use installation tool (9) to position seal ring (1) and the
rubber toric ring squarely against seal ring housing (5),
as shown.
14-5
