TM 5-3895-383-24
Axle (Rear)
SMCS Code: 3259; 3260; 3278
Part No.: 136-9111
Illustration 10
(1) Axle shaft end play ......................................... .025 to .076 mm
(0.0010 to .0030 inch)
NOTE: Use one axle shaft end play spacer for the
required thickness.
Spacers are used to adjust the shaft end play.
9R-2435 Spacer ....................................1.24 mm (0.049 inch)
9R-2436 Spacer ...................................1.35 mm (0.053 inch)
9R-2437 Spacer ....................................1.45 mm (0.057 inch)
9R-2438 Spacer ....................................1.55 mm (0.061 inch)
9R-2439 Spacer ....................................1.65 mm (0.065 inch)
9R-2440 Spacer ....................................1.75 mm (0.069 inch)
9R-2441 Spacer ....................................1.85 mm (0.073 inch)
9R-2442 Spacer ....................................1.96 mm (0.077 inch)
9R-2443 Spacer ....................................2.06 mm (0.081 inch)
9R-2444 Spacer ....................................2.16 mm (0.085 inch)
9R-2445 Spacer ....................................2.26 mm (0.089 inch)
(2)
Torque for the axle shaft retaining bolt
(not shown) .............................................. 217 N m (160 lb-ft)
The axle bearing preload rolling torque should be 2.3 to 5.6
Nm (20 to 50 lb-in) for earlier axles that have a conventional
seal.
The axle bearing preload rolling torque should be 2.3 to 9.0
Nm (20 to 80 lb-in) for later axles that have a cartridge seal.
10-21
