TM 5-3895-383-10
Operation Section
4-45
Transportation Information
Illustration 64
The steering frame lock pin in the raised position.
1. In order to hold the yoke rigid, install the steering
frame lock pin (1). Remove the retaining pin (2).
Illustration 65
The steering frame lock pin is in the locked position.
2. Lower the steering frame lock pin (2) into the proper
position. Reinstall the retaining pin (1).
Illustration 66
3. Attach two lifting cables to the rear of the machine.
There is one lifting eye on each side of the rear of
the machine. The lifting eyes are identified by a
“LIFT” stencil.
Illustration 67
4. Attach two lifting cables to the front of the machine.
There is one eye on each side of the front of the
machine. The lifting eyes are identified by a “LIFT”
stencil.
5. Connect the four lifting cables to the spreader bars.
The spreader bars must be centered over the
machine.
6. Lift the machine and move the machine.
Illustration 68
NOTICE
Failure to support yoke before tying roller down
may cause damage to rubber mounts between
drum and yoke.
7. When the machine is positioned, place blocks in
front of the drum. When the machine is positioned,
place the blocks behind the tires. Support the drum
yoke with suitable blocks or jack stands.
