TM 5-3895-382-24
Vibratory Bearing Reservoir
Change Lubricant
NOTE: To achieve adequa te draining, block the
drum up on the left side with an eight inch
block.
1.
Move the machine until the boss is at the top.
2.
Remove drain/fill plug (1) and allow the lubricant to
drain. Dispose of used lubricant according to
local, state and federal regulations.
3.
Clean and install drain plug (1).
4.
Move the machine until the boss is at the bottom.
5.
Remove drain/fill plug (1) at the top of the drum
head.
6.
Add lubricant. See "Lubricant Specifications" in
the "Maintenance Section".
7.
Maintain lubricant to the center of sight gauge (2).
Sight gauge (2) is not visible in the photo, but is
located approximately 90 from fill plug (1).
8.
Clean and install plug (1).
Maintenance Section
1-87
Every 1000 Service Hours or 1 Year
