TM 5-3895-382-24
Propel Control Linkage Adjustment
Make reference to WARNING on first page of Testing and
Adjusting.
Propel Control Linkage Adjustment
(1) Bracket. (2) Bolts. (3) Propel cable.
1.
Place propel control lever at operator console in the
NEUTRAL position.
2.
Loosen two bolts (2) in bracket (1) that propel cable (3)
is attached to on the axle pump.
3.
Move the bracket till the ball of the neutral start switch is
engaged in 1.5 mm (.06 in). Adjustment of the tie rod is
required so both pumps remain in neutral. Tighten the
two bolts.
4.
Start the engine. Move the propel handle forward and
when machine starts moving, shut the key switch off.
Now try starting the engine again. If adjustment is
properly made, the machine should not start until the
handle is returned to the neutral position.
5.
The operation works the same with the propel handle in
the reverse direction.
Manual Displacement Control Neutral Adjustment
Machine can lurch in either direction if the machine is not
properly raised off the ground and supported (wheels and
drum off the ground completely) during the adjustment.
Personal injury or death can result. Be sure the area is
clear of all personnel and equipment while testing and
adjusting.
Tools Needed
A
8S-7640
Stand
4
8S-7611
Tube
4
8S-7615
Pin
4
8S-8048
Saddle
4
NOTE:
Place machine on jack stands, supporting the
machine at four points, one stand supporting
each side of the frame at the rear of the machine,
and one jack stand supporting each side of the
yoke at the front of the machine. Use tooling (A)
to support both the rear and the yoke of the
machine.
11-42
