TM 5-3895-382-24
5.
Disconnect two fuel lines (3).
6.
Cap the lines or plug the lines immediately.
Illustration 6
Typical example.
7.
Remove three bolts (4) that hold two fuel lines (3) on the
rear of the engine.
Illustration 7
Typical example.
8.
Remove two bolts (5).
9.
Remove fuel filter base (6).
NOTE:
Use the following steps in order to remove fuel
filter (9). The fuel filter assembly has a bayonet
type lock ring that allows the fuel filter to drain
into the canister for easy removal.
a.
Remove cap (7). Remove the top plate, the O-ring,
and the bayonet type lock ring from fuel filter (9). This
will allow fuel to flow into the canister of the fuel filter.
b.
Turn collar (8) in the counterclockwise direction in
order to remove fuel filter (9).
c.
Pull fuel filter (9) from fuel filter base (6).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 8
Typical example.
1.
Install fuel filter base (6) on the engine.
2.
Install two bolts (5).
NOTE:
If the fuel filter was removed, use the following
steps to install the fuel filter:
a.
Replace the seal on fuel filter base (6).
b.
Insert fuel filter (9) in fuel filter base (6).
c.
Install collar (8). Turn the collar in the clockwise
direction in order to lock fuel filter (9) in place.
d.
Install the bayonet type lock ring, the O-ring, and the
top plate in fuel filter (9). Install cap (7).
Illustration 9
Typical example.
7-6
