TM 5-3895-382-24
8.
The oil supply line from the oil pan is restricted.
The oil supply line must be repaired or replaced.
9.
The turbine housing is damaged or restricted.
The turbine housing must be repaired or replaced.
10.
The bearings of the turbocharger are worn.
Replace the bearings.
11.
Excessive dirt exists in the compressor housing.
Clean the compressor housing.
12.
Carbon has collected behind the rotor of the turbine.
Remove the carbon.
13.
The engine rpm increases too rapidly when the engine
is started.
Check the fuel injection pump for correct operation and
settings.
14.
The period of time at high idle is insufficient.
Check the fuel injection pump for correct operation and
settings.
15.
Lubricating oil is leaking from the oil supply line.
The oil supply line must be repaired or replaced.
16.
A restriction exists in the bearing housing of the
turbocharger.
The bearing housing must be repaired or replaced.
17.
A restriction exists in the lubricating oil filter.
Clean the oil filter base and the housing for the oil filter.
Check the operation of the bypass valve in the oil filter
base. Replace the oil filter.
18.
The engine stopped too soon from a high load condition.
Check the following components for correct operation or
damage:
compressor impeller of the turbocharger
coolant system
fuel injection pump
air/fuel ratio control
wastegate
valve lash
fuel injector nozzles
Problem 13
Worn Bearings, Bearing Bores, and Journals
Probable Cause
1.
A restriction exists in the tube between the air filter and
the turbocharger.
The component must be repaired or replaced.
2.
A restriction exists in the exhaust system.
The component must be repaired or replaced.
3.
The turbocharger is loose or the clamps and bolts on
the turbocharger are loose.
Correctly position the turbocharger and tighten the
clamps and bolts.
4.
The flow of the lubricating oil is delayed to the
turbocharger when the engine is started. Insufficient oil
flows to the turbocharger when the engine is running.
Check the following components for correct operation:
oil pump
the engine oil bypass valve
the bypass valve in the oil filter base
oil filter
viscosity of the oil
restrictions in oil lines
5.
The lubricating oil is dirty.
Drain the lubricating oil. Install the correct type of
lubricating oil. Replace the oil filter.
6.
The incorrect type of lubricating oil is installed.
Drain the lubricating oil. Replace the oil filter. Install the
correct type of lubricating oil.
7.
The oil supply line from the oil pan is restricted.
The oil supply line must be repaired or replaced.
8.
The engine rpm increases too rapidly when the engine
is started.
Check the fuel injection pump for correct operation and
settings.
9.
The period of time at high idle is insufficient.
Check the fuel injection pump for correct operation and
settings.
6-36