TM 5-3895-382-24
(18)
Remove two screws (7) and washers (8) from bumper assembly (6).
(19)
Remove four scraper plates (4) and two scraper plates (5) from mounting posts (9).
(20)
Install two screws (7) and washers (8) in bumper assembly (6).
NOTE
Center plates should be installed before outer plates to allow correct positioning of
all plates.
(21)
Install four scraper plates (4), two scraper plates (5), and twelve scrapers (3) on bumper assembly (6) with
twenty-four bolts (1) and washers (2). Snug, but do not tighten bolts.
(22)
Position four scraper plates (4) and two scraper plates (5) to allow 9/16 in. (15mm) clearance between scraper
plate tips and drum surface.
(23)
Tighten bolts (1) to 340 lb-ft (460 Nm).
NOTE
Follow-on Maintenance: Remove chocks.
END OF TASK
2-56
