TM 5-3895-382-24
b. Installation.
NOTE
Boot end of cable goes to NATO
receptacle.
(1)
From under roller, feed positive cable (17) up to
starter assembly (29), going over solenoid.
(2)
From beside roller, install positive cable (17) on
starter assembly (29) with nut (30). Tighten nut.
(3)
Slide cable cover (26) over positive (+) terminal
(27).
(4)
From under roller, install negative cable (18) on
battery disconnect switch (1) with lock washer
(31) and nut (30).
(5)
Feed cables (17) and (18) to NATO receptacle
(19).
(6)
From beside roller, install two cables (17) and
(18) on NATO receptacle (19) with two lock
washers (16) and screws (15).
(7)
Slide cable cover (13) over positive (+) terminal
(14).
(8)
If removed, install clip (24) on hose (25).
(9)
Install screw (20), plate (21), two clamp halves
(22), and plate (23) on clip (24) and two cables
(17) and (18).
(10)
From under roller, install two cables (17) and
(18) on plate (35) with two clamp halves (34),
plate (33), and screw (32).
(11)
Close left side door assembly.
2-42
