TM 5-3895-382-24
e. Installation.
WARNING
·
Blade assembly weighs 800 lbs (363 kg). Keep clear of equipment when
equipment is being raised or lowered. Equipment may fall and cause serious
injury or death to personnel.
·
Do not allow heavy components to swing while hanging by lifting device.
Equipment may strike personnel and cause injury or death.
·
Exercise extreme caution when working near a cable or chain under tension. A
snapped cable, shifting or swinging load may result in injury or death to
personnel.
(1)
Using lifting device, position blade assembly (5) in yoke (10).
(2)
Determine amount of shims required to center blade assembly (5) in yoke (10).
NOTE
·
Any bolts used for placement of bar during assembly should be removed
during installation of blade assembly to yoke.
·
Shims are required if gap between yoke and blade assembly is greater than
2mm.
(3)
Install six washers (7), bolts (8), washers (8), and nuts (6) in plates (22), any shims (9), and yoke (10).
(4)
Tighten two nuts (20) to 340 lb-ft (460 Nm).
(5)
Install cylinder rod (4) on blade assembly (5) with washer (2), bolt (3), washer (2), and locknut (1). Tighten
locknut to 340 lb-ft (460 Nm).
NOTE
Follow-on Maintenance: Remove chocks.
END OF TASK
2-34
