TM 5-3895-379-23
HORN ASSEMBLY REPLACEMENT - CONTINUED
0102 00
REMOVAL - CONTINUED
2.
Remove locknut (5), washer (6), screw (7) and horn
10
assembly (8) from clip (9). Discard locknut.
7
4
14
NOTE
6
11
6
13
5
6
Tag and mark all wires prior to removal.
12
9
3.
Remove two screws (10), washers (11), wires (12
and 13) and lockwashers (14) from horn assembly
9
(8). Discard lockwashers.
4.
Remove screw (7), washer (6) and clip (9) from
7
bumper assembly (4).
4
8
401-518
INSTALLATION
1.
Install clip (9) on bumper assembly (4) with washer (6) and screw (7). Tighten screw to 15-25 lb-ft (20-34 Nm).
2.
Install two wires (12) and (13) on horn assembly (8) with two new lockwashers (14), washers (11) and screws (10).
3.
Install horn assembly (8) on clip (9) with screw (7), washer (6) and new locknut (5). Tighten locknut to 15-25 lb-ft
(20-34 Nm).
0102 00-2
