TM 5-3895-379-23
INTAKE MANIFOLD REPLACEMENT - CONTINUED
0025 00
REMOVAL - CONTINUED
7.
Loosen nut (14) and disconnect tube (15) from intake
22
19
21
manifold nipple (16).
8.
Remove four screws (17), screw (18) and screw (19),
two gaskets (20), gasket (21) and intake manifold (9)
from cylinder head (22). Discard gaskets.
INSTALLATION
15
NOTE
16
Ensure gasket surfaces are clean and
dry before installation.
14
Ensure manifold gaskets for front and
18
rear are positioned with notch at top
left when installed on cylinder head.
8
NOTCH
Center gasket can be installed either
17
way.
20
401-281
Do not use any sealant when installing
gaskets.
1.
Install two new gaskets (20), new gasket (21) and intake manifold (8) on cylinder head (22) using four screws (17),
screw (18) and screw (19). Tighten screws to 24 lb-ft (33 Nm).
2.
Connect tube (15) to intake manifold nipple (16) and tighten nut (14) to 35-71 lb-ft (47-96 Nm).
3.
Install new gasket (13) and intake manifold flange (16).
4.
Install clip (11) and for CB534B Roller, clip (12) on intake manifold (9) using four bolts.
5.
Slide hose at intake manifold flange (6) into position and tighten two hose clamps.
6.
For CB534B Roller, install clip (8) and screw (7) to intake manifold (9).
7.
Connect fuel line (4) to cold start heater (5) and tighten nut (3).
8.
Connect wire (1) to cold start heater connector (2).
9.
10.
11.
Start engine and check for leaks (TM 5-3895-379-10).
END OF WORK PACKAGE
0025 00-3/(0025 00-4 Blank)