TM 5-3895-379-23-2
0259
REMOVAL
WARNING
Oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause
injury.
CAUTION
Wipe area clean around all hydraulic connections to be opened during removal. Cap oil lines
and plug openings after removing lines. Contamination of hydraulic system may cause
premature failure.
NOTE
Use the same procedure as shown for all hydraulic lines, hoses, and fittings.
Tag and mark all hydraulic lines to ensure correct installation.
Use drain pan to catch any hydraulic oil that may drain from system. Dispose of oil IAW
local policy and ordinances. Ensure all spills are cleaned up.
1.
For lines held in position with clamps, remove nut (Figure 1, Item 7), washer (Figure 1, Item 6), bolt
(Figure 1, Item 3), washer (Figure 1, Item 4), and clamp (Figure 1, Item 5) from lines.
2.
For hydraulic lines with elbow fittings, disconnect lines (Figure 1, Item 14) from fitting (Figure 1, Item 10).
Remove two O-rings (Figure 1, Items 8 and 9) from fitting and discard O-rings. Remove fitting.
3.
For hydraulic lines with elbow bosses, disconnect line (Figure 1, Item 1) from elbow boss fitting
(Figure 1, Item 2).
4.
Remove elbow boss fitting (Figure 1, Item 2) from valve check (Figure 1, Item 12).
5.
Remove check valve (Figure 1, Item 12), O-ring (Figure 1, Item 11), and gasket (Figure 1, Item 13). Discard
O-ring and gasket.
0259-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00197)