TM 5-3895-379-10
WATER SPRAY NOZZLE CHECK AND SERVICE - CONTINUED
0025 00
CLEANING AND INSPECTION
1.
Clean screen, seal, nozzle and clamp with non-sudsing detergent and water. Remove difficult deposits with a stiff bristle
brush.
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Failure to follow this warning may result in injury or death. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user must wear
protective goggles or face shield.
2.
Use a cleaning cloth or compressed air to dry metal parts.
3.
Check cap and clamp for cracks and wear on locking parts.
4.
Check screen for crushing, corrosion or tears.
5.
Check seal for cracks, tears or other signs of deterioration.
6.
Check nozzle for clogging, corrosion or excessive wear.
7.
Notify supervisor for replacement of lost or damaged parts.
INSTALLATION
NOTE
Slot in nozzle faces down (toward drum surface) when installed.
1.
Install nozzle (5), seal (4) and screen (3) in cap (1).
2
4
3
1
5
REMOVE
INSTALL
SLOT
401-121
0025 00-2
