TM 5-3895-379-10
OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED
0006 00
OPERATE IN EXTREME COLD - CONTINUED
3.
Start Engine (CB534C).
WARNING
DO NOT use ether starting fluids to start roller in extreme cold weather. The CB534C Roller is equipped
with an inlet manifold heater. The use of ether could result in injury, or engine damage.
a.
Open right door assembly and turn battery dis-
25
connect switch to ON position (WP 0005 00).
5
b.
Push down parking brake knob (24) to apply
parking brake.
c.
Move propel control lever (5) to NEUTRAL
position.
24
d.
Push vibration push switch (25) to OFF position.
e.
Move water spray switch (26) to center position.
26
401-2006
f.
Move throttle control switch (27) to FAST position.
g.
Turn engine start switch (6) to ON position.
NOTE
Do not press air inlet heater switch for
more than 30 seconds without attempting
to start engine. Allow inlet heater 60 sec-
onds to cool down if engine is not cranked.
h.
Press and hold air inlet heater switch (28) for a
minimum of 10 seconds and up to a maximum of
28
30 seconds, depending on outside air tempera-
ture.
i.
Turn engine start switch (6) to START position.
When engine starts, release key.
j.
Disengage starter if engine does not start. Con-
6
27
tinue to press throttle control switch (27).
NOTE
Air inlet heater may be used after starting
engine if engine is running rough.
k.
Repeat step i after 10 seconds.
l.
When engine starts, continue to press and hold
401-2005
air inlet heater switch (28) until engine runs
smoothly.
m.
Move throttle control switch (27) to SLOW posi-
tion after engine starts.
0006 00-10
