TM 5-3895-379-10
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
OPERATE ENGINE - CONTINUED
WARNING
DO NOT start roller engine in enclosed areas without adequate ventilation. Failure to follow this warning
may result in permanent brain damage or death due to carbon monoxide poisoning.
CAUTION
DO NOT operate starter motor for more than 30 seconds at a time. After 30 seconds, allow starter motor
to cool for at least two minutes before attempting to start engine again. Excessive heating of starter
motor may result in damage or early starter failure.
Keep engine rpm low until engine oil pressure indicator light and horn go off. Stop engine if indicator
light does not go off within ten seconds. Notify supervisor to perform troubleshooting before restarting
engine.
Failure to keep engine rpm low until engine oil pressure indicator light and horn go off can result in tur-
bocharger damage.
g.
Turn engine start switch key (16) to START (clockwise) position to crank engine. Release key when engine starts.
h.
On CB534B Roller only, immediately push and hold button (14) and push throttle control (13) down to low idle
position (near to or fully down) for engine warm up. Release button.
i.
On CB534B Roller only, when desired low idle is reached, turn throttle lock (12) clockwise to lock throttle control
(13) in position.
j.
On CB534C Roller only, push throttle control switch (15) to slow (TORTOISE) position once engine is started.
NOTE
Vibration push switch turns vibratory system on by pressing once or off by pressing again. There is no way
to tell if the vibratory system is on or off when the engine is not running.
k.
Ensure that vibration push switch (17) is turned off.
0005 00-8
