Fuel, Oil and Coolant Specifications
DETRIOT DIESEL
EXHAUST VALVE CLEARANCE ADJUSTMENT
The correct exhaust valve clearance at normal engine operating temperature is important for smooth, efficient operation
of the engine. Insufficient valve clearance can result in loss of compression, misfiring cylinders, and eventually burned
valve seats and valve seat inserts. Excessive valve clearance will result in noisy operation, especially in the low speed
range.
Whenever the cylinder head is overhauled, the exhaust valves reconditioned or replaced, or the valve operating
mechanism is replaced or disturbed in any way, the valve clearance must first be adjusted to the cold setting to allow for
normal expansion of the engine parts during the engine warm-up period. This will ensure a valve setting which is close
enough to the specified clearance to prevent damage to the valves when the engine is started. All of the exhaust valves
may be adjusted, in firing order sequence, during one full revolution of the crankshaft. Refer to the General
Specifications at the front of the manual for the engine firing order.
TWO VALVE CYLINDER HEADS
Cold Engine
1. Place the speed control lever in the idle speed
position. If a stop lever is provided, secure it in the no-
fuel position.
2. Remove the loose dirt from the valve rocker
cover(s) and remove the cover(s).
3. Rotate the crankshaft, manually or with the starting
motor, until the injector follower is fully depressed on the
cylinder to be adjusted.
If a wrench is used on the crankshaft
CAUTION:
bolt, do not turn the engine in a left-hand direction
of rotation as the bolt will be loosened.
4. Loosen the exhaust valve rocker arm push rod lock
nut.
5. Place a .012" feeler gage, J 9708, between the
valve stem and the rocker arm (Fig. 1). Adjust the push
Fig. 1 - Adjusting Valve Clearance (Two-Valve Cylinder Head)
rod to obtain a smooth pull on the feeler gage.
6. Remove the feeler gage. Hold the push rod with a
5/16"wrench and tighten the lock nut with a 1/2" wrench.
7. Recheck the clearance. At this time, if the adjustment is correct, the .010" gage will pass freely between the end of
the valve stem and the rocker arm and the .012 " gage will not pass through.
8. Check and adjust the remaining valves in the same manner as outlined above.
Hot Engine
Maintaining normal engine operating temperature is particularly important when making the final valve clearance
adjustment. If the engine is allowed to cool off before setting any of the valves, the clearance, when running at full load,
may become insufficient.
1. With the engine at normal operating temperature (160-185F or 71-85C), recheck the exhaust valve clearance with
feeler gage J 9708. At this time, if the valve clearance is correct, the .008" gage will pass freely between the end of the
valve stem and the rocker arm and the .010"gage will not pass through. Readjust the push rod, if necessary.
2. After the exhaust valve clearance has been adjusted, check the fuel injector timing.
Page 76
