SECTION 1
INTRODUCTION
1-6.
The unit serial number is located on the unit
1.
GENERAL.
nameplate. It is also stamped on the left hand side of the
gooseneck. The serial number indicates the design series,
1-2.
This manual contains Operation and Maintenance
manufacturing plant, serial number of the unit and year
Instructions for the
manufactured, Example B89 C 0000 T.
C350B Steel Wheel Roller (figure 1-3 and 1-4). Operating
instructions must be carefully reviewed and understood
1-7.
SYSTEM DESIGN SPECIFICATIONS.
before attempting to operate a unit. The individual
assigned to operate the unit should see that it is kept in
1-8.
Design specifications for individual systems of the
good condition to ensure prolonged efficiency.
unit are listed: in Section 2. Maintenance Specifications are
given in Section 4.
1-3.
UNIT NAMEPLATE.
1-9.
OPERATING INSTRUCTIONS.
1-4.
The unit nameplate is located at the front of the
operator's compartment as shown in figure 1-4. Make sure
1-10. All instructions necessary for safe and efficient
the nameplate remains attached to the unit at all times.
operation are given in Section 3.
NOTE: Make sure that nameplate information is complete.
1-11.
HYSTER--CARE MAINTENANCE.
If not, contact a Hyster Dealer.
1-12. Section 4 Contains the schedule and procedures
1-5.
SERIAL NUMBER DATA (see figure 1-4).
required for proper maintenance. The schedule lists
recommended time intervals between maintenance
CAUTION: The COMPLETE serial number must be
checks. The procedures provide detailed instructions for
identified
when
ordering
parts
or
performing maintenance checks.
communicating service information to Hyster
Company.
1-13.
TROUBLESHOOTING.
FIGURE 1-3.
1-2.