TM 5-3895-346-14
LUBRICATION
LUBRICATION CHART
LUBRICATION CHART
ITEM
LUBRICATION
NO
POINTS
LUBRICANT
INSTRUCTIONS
EVERY DAY OR 8 WORKING HOURS
1
Roll Stub Axle
GAA Grease
One fitting each of the
roll thrust cap. Lubri-
cate until grease ap-
pears from under seal
in inner end of bush-
ing next to roll head.
EVERY WEEK OR 50 WORKING HOURS
2
Jackshaft Pillow
GAA Grease
One fitting each.
Block and Flange
Bearing
3
Eccentric Shaft
G080W/90
Check oil level plug on
both sides. Plug lo-
cated on bearing hous-
ing flange near roll
head .*
*Check each morning before operating roller. The roller must be on level ground when
checking oil level and roll should be in a position so that the fill-drain plug (1-inch pipe
plug) is in the top most position. This will put the oil level plug (3/8-inch pipe plug) in
its proper location as shown in fig. 4.
4
Drive Sheave
GAA Grease
1-90fitting on in-
side frame above eccen-
tric drive shaft.
5
Eccentric U-Joint
GAA Grease
One fitting on slip
Slip Spline
joint.
EVERY 6 MONTHS OR 1000 WORKING HOURS
3
Eccentric Shaft
G080W/90
Drain and refill (see
special instructions
for 50-hour check).
6
Eccentric U-Joint
GAA Grease
Two fittings - one each
and Outer Cross
cross.
35
