APPENDIX D
REPAIR PARTS LIST
Section I.. INTRODUCTION
D-1. Scope
Code
Explanation
a. This appendix lists repair parts, special tools, test
P
Repair parts, Special Tools and Test Equipment supplied
and support equipment required for the performance of
from the GSA / DSA, or Army supply system and
organizational, direct support and general support
authorized for use at indicated maintenance categories.
maintenance of the roller.
P2
Repair parts, Special Tools and Test Equipment which are
b. Repair parts listed represent those authorized for
procured and stocked for insurance purposes because
the combat or military essentiality of the end item dictates
use at indicated maintenance levels and will be
that a minimum quantity be available in the supply
requisitioned (on an "as required" basis until stockage is
system.
justified by demand in accordance with AR 735-35 or AR
M
Repair parts, Special Tools and Test Equipment which are
710-2).
not procured or stocked, as such, in the supply system
but are to be manufactured at indicated maintenance
D-2. General
levels.
This Repair Parts and Special Tools List is divided into
A
Assemblies which are not procured or stocked as such, but
the following sections:
are made up of two or more units. Such component units
carry individual stock numbers and descriptions, are
number sequence, of repair parts authorized at the
procured and stocked separately and can be assembled
to form the required assembly at indicated maintenance
organizational level for the performance of maintenance,
categories.
including those items which must be removed for
X
Parts and assemblies that are not procured or stocked
replacement of the authorized item. Items are listed by
because the failure rate is normally below that of the
assembly group in top down breakdown sequence.
applicable end item or component. The failure of such
part or assembly should result in retirement of the end
b. Special Tools, Test and Support Equipment-Section
item from the supply system.
III. A list of special tools, test and support equipment
X1
Repair parts which ire not procured or stocked. The
authorized for the performance of maintenance at the
requirement for such items will be filled by use of the next
organizational level. (Not Applicable)
higher assembly or component.
X2
Repair parts, Special Tools and Test Equipment which are
not stocked and have no foreseen mortality. The
number sequence, of the repair parts authorized for the
indicated maintenance level requiring such repair parts
performance of maintenance at the direct support and
will attempt to obtain the parts through cannibalization or
general support levels, including those items which must
salvage, if not obtainable through cannibalization or
be removed for replacement of the authorized item.
salvage, the item may be requisitioned with exception
data, from the end item manager, for immediate use.
Items are listed by assembly group in top down
G
Major assemblies that ore procured with PEMA funds for
breakdown sequence.
initial issue only as exchange assemblies at DSU and
d. Federal Stock Number and Reference Number
GSU level. These assemblies will not be stocked above
DS and GS level or returned to depot supply level.
NOTE
ascending numerical sequence, followed by a list of
Cannibalization or salvage may be used as a source of supply
reference numbers appearing in all listings, in ascending
for any items source coded above except those coded X1 and
alpha-numeric sequence, cross-referenced to the
aircraft support items as restricted by AR700-42.
illustration figure and item number.
(2) Maintenance code indicates the lowest level of
3. Explanation of Columns
maintenance authorized to install the listed item. Repair
The following provides an explanation of columns in the
parts and special tools assigned Maintenance Code "C"
may be stocked at the operator level of maintenance
a. Source, Maintenance, Recoverability Codes (SMR).
when authorized by the Unit Commander.
The
(1) Source code indicates the source for the listed
maintenance level codes are:
items. Source Codes are:
D-1