This table is included for information only and is not to be used for requisitioning tools or equipment.
Table VI. Field and Depot Maintenance Tools and Equipment
References
Item
Stock No.
Use
Fig.
Par.
Compressor --------
41-2430.500.700-------
86
178
Piston rings.
Extractor-------------
41-E-555-20 ------------
----------
187
Carburetor plug.
Growler --------------
17-5940 ------------------
110
191
Armatures.
Lifter and com- ---
41-5329.200.300-------
52
136
Valve and valve spring.
pressor.
Puller -----------------
41-6272.275.513-------
89
180
Crankshaft pulley.
Puller -----------------
41-6272.355.305-------
----------
184
Crankshaft and water
pump.
Puller -----------------
41-6272.750.500------- ----------
182
Timing gear.
Wrench --------------
41-W-1496 -------------- ----------
187
Carburetor fuel valve
seat.
Wrench --------------
41-W-1560 --------------
----------
187
Carburetor main jet.
Wrench --------------
41-W-1866 --------------
----------
187
Carburetor power jet
valve.
Wrench --------------
41-W-1868 --------------
----------
187
Carburetor power jet
valve.
173. Specially Designed Tools and Equipment
No specially designed tools and equipment are required for the over-haul of this road roller.
Section III. ENGINE
174. Engine Removal
a. General. Use a reliable overhead or motorized crane for removal of the engine. The most practical way to attach
the crane cables to the engine is to remove two or more cylinder head screws and attach the lifting chain to the cylinder
block. The crane cables or crane hook can be then attached to the lifting chain. If a lifting chain is not available, wrap
strong manila rope or steel cables around the engine.
b. Removal Procedure (fig. 81).
(1) Remove the steering roll top cover (par. 161).
(2) Remove the operator's platform (par. 162).
(3) Remove the compression roll housing (par. 158).
(4) Drain the cooling system (par. 128).
(5) Remove the radiator (par. 129).
(6) Drain the oil pan (par. 126).
(7) Remove the hydraulic pump belt (par. 150).
(8) Disconnect the exhaust pipe from the exhaust manifold and remove the exhaust pipe (par. 133).
201