TM 5-3895-382-24
9.
Put a thin film of clean oil on the seal faces. Use an
applicator, a disposable tissue or a clean finger to
distribute the oil evenly. Be careful not to get any oil on
the rubber toric rings.
10.
Make sure both housings (5) are in correct alignment
and are concentric. Move the parts slowly and carefully
toward each other.
NOTICE
Do not slam seals together. High impact can scratch or
break the seal components.
11.
Once in place, fasten all parts tightly.
Operators Platform
Tilt & Lower Operators Platform
7352-084
Tools Needed
A
8S-9906
Rachet Puller
1
1.
Remove bolts and nuts (1) from storage locations (X).
Install bolts (1) at the pivot as shown.
2.
Remove bolts (2).
3.
Remove bolts and nuts (3) from the operators platform.
16-7